Failure mechanisms of stackbonded masonry.10mm 3mm mortar joint Bedding reinforcement should Bricks should be identical in size to ensure that the strong vertical alignment desirable in stack bond is achieved. A stack bond is the brick bond pattern to choose if you are looking to really show off and make your bricks aesthetic qualities shine. A continuous vertical joint is the key characteristic of stack bond, requiring careful set-out of bricks. (610 mm), and the cross wires must be W1.7 (9 gage, MW11) minimum, without drips, and embedded in mortar. The vertical spacing of the joint reinforcement can not exceed 24 in. example of frogged brick example of cored brick. When two wythes of masonry are bonded with joint reinforcement, at least one cross wire must serve as a tie for each 2 ft (0.25 m) of wall area. #Masonry stack bond how to#How to adequately account for continuous perpend joints. for stack bond, including frogged and cored bricks.Their classification as loadbearing and non-loadbearing walls.This requirement shall apply to unit masonry walls and veneers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |